3/14/2024 0 Comments Grbl controller ampsG code but the wrong is I mives in visualizer (shows ) but the motor is not When I connectĪrduino to pc it is fine, I upload grbl. The problem is all things are fine in software (I think). My cnc machine using the arduino uno, cnc shieldv3.0, nema 17 with dev8825ĭriver grbl v0.8c/ v0.9i/ 0.9j with the respective baud rate I.e, 9600 andġ15200 used ide to flash the grbl and grbl controller for sending g code. I have got a problem with my homemade cnc pen plotter.I have made Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you are subscribed to this thread. I think I have wired corrctly.I also change the wire also a1b1a2b2 to a1a2b1b2 thinking it will work but its same as previously. I have adjusted the vref to 0.8 amps(v) power with 12v 1 amp dc. I opend grbl controller and send g code but the wrong is I mives in visualizer (shows ) but the motor is not moving and making unpleasant sound. When I connect arduino to pc it is fine, I upload grbl. I have got a problem with my homemade cnc pen plotter.I have made my cnc machine using the arduino uno, cnc shieldv3.0, nema 17 with dev8825 driver grbl v0.8c/ v0.9i/ 0.9j with the respective baud rate I.e, 9600 used ide to flash the grbl and grbl controller for sending g code. Both leds should light.If not, swap the cables until both light.Įl mié., oct. Put two leds between a1-a2 and b1-b2 and turn the motor axle by hand.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |